how to change nat type to open with linksys router

Every computer out there is set up slightly differently - different makes/models of modems and/or routers, different software firewalls, different antivirus programs, receiving service from different providers - these are all factors that must be considered when attempting to solve a NAT error.

Understand what a NAT problem is īasically, a Network Address Translation problem is caused by a router not being able to do what it's supposed to it is not correctly re-directing data it has received from the outside world to a computer that is connected to it (the one running Vuze in this case).Ĭan this page assist you to resolve the NAT issue? That entirely depends on several factors.

Some firewalls have a generic setting to prevent incoming (WAN) connections, this should be disabled too.

For application-based firewalls you have to allow Vuze.exe (or javaw.exe) to access the internet and accept incoming connections.

If the firewall is port based you have to allow incoming connections to the UDP and TCP ports used by Vuze (tools -> options -> connection).

Software firewalls and antivirus software including firewalls:.

Sadly some routers that claim to support UPnP don't interoperate with Vuze correctly, if that's the case have a look at point a). Just enable the UPnP/NAT-PMP plugin under tools -> options -> plugins -> UPnP and set it to report everything to get some feedback, once it works you can turn the messages off again.

Turn off UPnP in Vuze in Tools > Options > Plugins > UPnP, since it may confuse some routers that do not support or correctly support UPnP.

Note: The exact wording is different for each router, thus it might be called port forwarding, opening pinholes through the firewall, NAT rules, virtual server or something else.

Setup port forwarding by setting up rules to forward Vuze' listening ports (UDP and TCP) as external ports to the IP of your computer and the same ports on your computer.log into your router (if you don't know its address read the manual or determine the gateway address, which should be the address of your router).don't use DHCP) or use your router's MAC-address binding to allocate a specific IP to your network card you have to set your PC to a static IP (i.e.There are several causes of reachability problems: Here's a quick outline of what you have to do for more detailed explanations and instructions have a look at the next chapter. To fix a NAT issue, you have to consider multiple factors that can cause it.

How to change nat type to open with linksys router